Something’s wrong

To make a long story short;

I can’t come up with the drawing for the bending fixture that looks even close to what I have seen on a photo with Pascal (see right) bending his tube for the rib at Robert’s workshop. So I will have to ring Robert himself!

1388922945

1388923088Something else I had on my todo list was drilling out the holes for the pin in the hinges as shown here (on the elevator). These pins are very hard to get in, and drilling them out once they are installed is almost impossible as there is no room. So I did this for the 16 hinge bits I have sitting here for the ailerons.

All done….. a perfect fit. All I need now is get the correct drawing for the bending fixture………………….

Leave a comment